> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://support.eatos.com/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# Verifone P400


### Introduction

This article will go over the steps in setting up your card reader to begin taking payments

![](https://storage.crisp.chat/users/helpdesk/website/-/7/4/2/6/74260be74e639800/f1e8ae277cbfbe207ac7e60a2f65b8_ix8sr2.jpg)

### Table of Contents

* [Supplied Components](#3-supplied-components)
* [Powering on P400](#3-powering-on-p400)
* [Connect to your Network](#3-connect-to-your-network)
* [Rebooting](#3-rebooting)


---

### Supplied Components

* P400 Plus payment terminal
* Power Supply 
* Ethernet dongle
* Privacy Shield

![](https://storage.crisp.chat/users/helpdesk/website/-/7/4/2/6/74260be74e639800/img9895_70uy7u.jpg =600x400)


---


### Powering on P400

**Step 1:** Face the terminal. Face down on a soft and clean surface to protect the lens from scratches. 

**Step 2:** Slide out and lift the compartment cover with captive screw **A**, then attach the 28-pin connector of the cable to the terminal **B**. Slide back compartment cover and tighten the captive screw as shown in figure **C**

![](https://storage.crisp.chat/users/helpdesk/website/-/7/4/2/6/74260be74e639800/img9893_zj9x0i.jpg =1000x400)

**Step 3:** Connect the power cable to the Ethernet dongle. 

**Step 4:** Place the power cable into the wall. The device will begin to power on if connected correctly.


---


### Connect to your Network

### Connect to Ethernet LAN

* Connect an Ethernet cable to the Ethernet (LAN) port on the dongle. That is the port marked with ETH or refer to the image below.

|| Note: Connecting the wrong type of cable to the Ethernet port or connecting the Ethernet cable to the wrong port (for example, the RS232 port) may severely damage the terminal.

![](https://storage.crisp.chat/users/helpdesk/website/-/7/4/2/6/74260be74e639800/img9896_lf8kpq.jpg)

### Connect to WI-FI
 
**Step 1:** On the terminal display, select **Configure network**

**Step 2:** Select **WI-FI**

**Step 3:** Turn on the **WI-FI** toggle switch

**Step 4:** Select the **+** icon to add a network. The terminal scans for WI-FI networks. 

**Step 5:** Choose the desired network from the list and enter the WI-FI password or select **Add**.

Step 6: Select the check mark to confirm. The terminal


---


### Rebooting

### Reboot the terminal

1. Go to **Settings** and select **Power**
2. Enter your **passcode**
3. Select **Restart** and confirm