Verifone P400
Introduction
This article will go over the steps in setting up your card reader to begin taking payments
Table of Contents
Supplied Components
- P400 Plus payment terminal
- Power Supply
- Ethernet dongle
- Privacy Shield
Powering on P400
Step 1: Face the terminal Face down on a soft and clean surface to protect the lens from scratches.
Step 2: Slide out and lift the compartment cover with captive screw A, then attach the 28-pin connector of the cable to the terminal B. Slide back compartment cover and tighten the captive screw as shown in figure C
Step 3: Connect the power cable to the Ethernet dongle.
Step 4: Place the power cable into the wall. The device will begin to power on if connected correctly.
Connect to your Network
Connect to Ethernet LAN
- Connect an Ethernet cable to the Ethernet (LAN) port on the dongle. That is the port marked with ETH or refer to the image below.
Connect to WI-FI
Step 1: On the terminal display, select Configure network
Step 2: Select WI-FI
Step 3: Turn on the WI-FI toggle switch
Step 4: Select the + icon to add a network. The terminal scans for WI-FI networks.
Step 5: Choose the desired network from the list and enter the WI-FI password or select Add.
Step 6: Select the check mark to confirm. The terminal
Rebooting
Reboot the terminal
- Go to Settings and select Power
- Enter your passcode
- Select Restart and confirm
Updated on: 07/30/2025
Thank you!